Garmin Varia Smart Bike Lights Owner s Manual - Page 6

3 Place a rubber pad around the seat post, if necessary: • If the seat post diameter is 27 to 28.6 mm, use the thicker pad. • If the seat post diameter is 30.4 to 31 mm, use the thinner pad. • If the seat post diameter is 31 to 31.8 mm, do not use a rubber pad. 4 Place the seat-post connector around the rubber pad. NOTE: You should align the contours on the rubber pad with the grooves on the inside of the seat-post connector. 5 Replace and tighten the screw. NOTE: Garmin recommends a torque specification of 7 lbf-in. (0.8 N-m). You should check the tightness of the screw periodically. 6 Align the tabs on the back of the device with the seat-post mount notches .  Varia HL Device Overview Device key Select to cycle through the headlight pairing, intensity, À and pattern modes. Hold to turn the device on and off. Status LED View device status (Bike Light Status LEDs, Á page 2). Varia TL Device Overview 7 Press down slightly and turn the device clockwise until it locks into place. Installing the Multi-Location Mount 1 Select a secure location to mount the taillight where it does not interfere with the safe operation of your bike. NOTE: You can mount the device on your seat post, helmet, backpack, or other location. Garmin recommends that you enable the deceleration indicator only when mounting the device vertically on your seat post. 2 If necessary, select the correct rubber pad for your seat À post shape. 3 Place the mount on the seat post or other mounting location. 4 Attach the mount securely using one or two bands . Á NOTE: You can use the hooks on the center of the mount  if using only one band. 5 Align the tabs on the back of the device with the mount notches . à 6 Press down slightly and turn the device clockwise until it locks into place. 2 Device key À Select to cycle through the taillight pairing, intensity, and pattern modes. Hold to turn the device on and off. Status LED (visible View device status (Bike Light Status LEDs, Á above the device page 2). key) Bike Light Status LEDs LED Activity Solid red Alternating blue and green Alternating blue and red Flashing green Solid green Flashing red Flashing blue Status An error occurred while charging. The device shut down to prevent overheating. The device is uploading settings from Garmin Express™. An error occurred while uploading settings from Garmin Express. The battery is charging. Charging is complete. The battery is low. The device is in smart mode and can be controlled by a paired wireless remote. Using the Device Key 1 Hold the device key for 1 second to turn on the device. The first time you turn on the device, it enters smart mode. The status LED flashes blue. The device can be controlled by a paired wireless remote or Edge device. 2 Select the device key to cycle through the bike light intensity and pattern modes. Taillight modes include smart mode, high, medium, low, and flash. Headlight modes include smart mode, overdrive, high, medium, low, and flash. NOTE: Taillight medium and flash modes are available on the Varia TL 300 device only. Headlight overdrive and flash modes are available on the Varia HL 500 device only. 3 Hold the device key for 2 seconds to turn off the device. The next time you turn on the device, it enters the last-used operating mode. Introduction