Garmin Varia Smart Bike Lights Owner s Manual - Page 8

3 Select the left or right turn signal. NOTE: You can select the same turn signal again to cancel the turn signal. Light Network Settings From your Edge device, select > Sensors > Varia > Light Network, and select a paired light. Enable: Turns on the light and allows you to control the light remotely with your Edge device. You can disable a light to disconnect it from the light network. Motion Activated: Automatically turns on the light when the Edge device is in motion. Auto Deceleration: Automatically adjusts the taillight intensity and pattern when decelerating sharply. NOTE: This setting appears when a taillight is paired with the device. NOTE: Taillight medium and flash modes are available on the Varia TL 300 device only. Light Mode: Sets the light intensity and pattern mode, or turns off the light. NOTE: This setting is available when the Individual configuration setting is selected (Configuration Settings, page 3). About: Displays device, software, and battery information. Remove: Allows you to delete a paired light from the network. Checking the Battery Level From your Edge device, select Network. > Sensors > Varia > Light The battery level for all paired lights appears. Testing the Light Network 1 From your Edge device, select > Sensors > Varia > Test Lights. 2 Select a light to test. The light blinks when it is connected. Taillight key. Select to signal a left turn when using two taillights. À Hold to cycle through the taillight intensity and pattern modes. Headlight key. Select to switch between low beam and high beam. Á Hold to cycle through the headlight intensity and pattern modes. Taillight key and power key. Select to signal a right turn when using  two taillights. Hold to turn all lights on and off. Status LED. à Status LED LED Activity Flashing green Alternating red and green 12 rapid green flashes Solid red 12 rapid red flashes Flashing red Status Searching for a paired device. Attempting to pair with a device. A turn indicator is on. Successfully paired with a device. Pairing failed or the connection was lost. A paired device entered power conservation mode. The light intensity is automatically adjusted to prolong battery life. One or more of the paired devices has a low battery. Pairing the Remote with Your Varia Device The first time you connect the Varia remote to your Varia device, you must pair the remote with your device. 1 Bring the remote within 1 m (3 ft.) of the device. NOTE: You must stay 10 m (33 ft.) away from other ANT+ sensors while pairing. 2 On the Varia device, hold the device key for 1 second to turn it on. 3 Select the Varia device key to enter smart mode. The status LED starts flashing blue. 4 On the Varia remote, hold two keys simultaneously until the status LED starts alternating green and red, and release the keys. The remote searches for your Varia device. After the remote pairs successfully, the status LED flashes green 12 times. After the remote is paired, it connects to your device whenever the device is in range and turned on. Using the Mounts Several mounts are available for your remote, either included with the product or as an optional accessory. The mounts allow you to attach the remote to your body, your bike, or other objects. • Align two of the notches with the sides of the mount, and À press the remote into the mount until it clicks. Wireless Remote Control Device Overview • Press gently on the release tab , and lift the remote from Á the mount. Replacing the Battery WARNING Do not use a sharp object to remove batteries. Keep the battery away from children. 4 Wireless Remote Control