Gastroback 40998 User Manual - Page 12

6. Rinse the lid and the beaker in warm detergent solution. 7. Rinse the blender jug, the lid and the beaker afterwards with clean water, dry the parts with a dish towel gently and let it dry out of the reach of small children at the air. Disassembling the Blender Jug and Removing Stubborn Residue WARNING: The blades of the knife are very sharp. Treat the blades carefully and without violence, be careful not to cut on the sharp blades and not to damage the blades. 8. Keep the blender jug over a sufficiently large bowl, turn the mount to the left and remove knifes and the sealing ring downwards. 9. Rinse all parts of the mixing jar in warm detergent solution. Soak the stubborn food residues on the parts for a few minutes and then remove these with a small plastic brush or sponge. While doing so be careful not to cut on the sharp blades. 10. Rinse the parts of the blender jug with clear water and dry the parts afterwards with a clean cloth gently. Let the parts (especially blades and bottom of the jug) dry in a protected and inaccessible to small children area at the air. Place the parts back together after drying (see: ›Assembling the Blender Jug‹). Cleaning the Motor Block WARNING: Always unplug the power cord before cleaning the motor base. Never pour water or other liquids on the motor base pour, run into the motor base or under the motor base. Never immerse the motor base in liquids or place on wet or damp surfaces. Wipe away spilled liquids immediately. At the bottom of the motor base are vents. Please ensure that no water can run or drip into these openings. 1. Unplug the power plug from the outlet. 2. Then wipe the motor base with a damp, not dripping cloth. Make sure to avoid damaging the drive wheel and bearing of the drive wheel in the centre of the socket. Never poke with fixed or hard objects in the mount of the motor base. Use a soft brush if necessary to clean the mount. If moisture gets into the mount of the motor base, clean and dry the mount very carefully and thoroughly. 3. Dry the appliance thoroughly. The entire motor base must be completely dry before you reassemble the appliance and use. Storage Assemble the blender jug for storage completely and correctly to avoid injury from the blade and loss of parts. Place the blender jug onto the socket of the motor base. In this way, the sealing ring, the knives and the drive wheel are protected best against dirt and damage. WARNING: Never place the bottom of the jug or the knives without the blender jug on the motor base. Important: Do not let the power cord slide across the floor and make sure that the power cord does not hang or can be caught. Store the appliance in a clean and dry place, where it is protected from excessive loads (impact, shock, dirt, humidity) and inaccessible to small children. Do not place hard or heavy objects on the appliance. The storage location should be protected from frost and not be warmer than 40 °C. 28