GE 6155 Installation Instructions - Page 3

Selecting Zone Detection Selecting One-Zone or Two-Zone Detection Position the jumper as shown to select one or two zone detection. Zone Patterns Top View Standard Mfg.0128 Two Zone (4 pulses) SENTROL REMOVE FOR TEST 6155XT-N One Zone (2 pulses) Listed U 3 2 K 9 L Intrusion detection unit  burglary 7-16VDC, 10mA (max) NC COM TMP TMP + - 2-Zone Detection 1-Zone Detection 40' 12.2m 30' 9.1m 20' 6.1m 10' 3.0m Each zone is made up of two beams, one positive and one negative. With one zone selected, the unit detects the intruder moving across one zone. With two zones selected, the unit detects the intruder moving across two zones. Two-zone detection is recommended to reduce chances of false alarms. 2 Beams +- 2 Beams +- 2 Beams +- 0 0 10' 3.0m 20' 6.1m 30' 9.1m 40' 12.2m Side View 6'10" 2.1m 30° 4° 15° Floor Line Vertical Barrier Top View One-Zone Detection Two-Zone Detection Wiring Strip back the outer jacket on the wiring cable. This will allow wires to flex in the case. Make sure the cable is slack in the wall to avoid stressing the wires at their connections. NC COM TMP TMP + - 6155XT Model POWER-IN: 7 TO 16 VDC 0' 6° Side View 6'10" 2.1m 3° 6' 0.9m 1.8m 19' 5.8m 29' 8.8m 34' 40' 10.4m 12.2m NC COM T/NO TMP + - 6157XT Model POWER-IN: 7 TO 16 VDC Note When mounting the unit at 6'10"(2.1m) (for typical coverage), align arrows on the ball joint shoe with zeroes on the ball joint. This is the 0° setting. For every 1' (0.3m) above the typical mounting height, tilt the shoe down 1°.For example, for 7'10" (2.4m), tilt down 1°; for 8'10" (2.7m), tilt down 2°; etc. 6150 Extended Temperature Series SharpShooter PIR 3