GE AEH25DL Owners Manual - Page 4

Safety Instructions About the controls on the air conditioner-models with touch pads. Lights next to the touch pads on the air conditioner control panel indicate the selected settings. The display always shows the room temperature except when setting the Set temperature or the Delay timer. Light indicates the unit is in the temperature or delay time Set mode. Operating Instructions Care and Cleaning Installation Instructions Light indicates Circulaire is on. Light indicates the delay timer is set. Delay 1-24hr Delay timer Decrease Mode select Fan speed Decrease Temperature set Increase and Decrease F Delay Mode Auto Fan an - Fan Temp Power + Delay timer Increase Circulaire Auto Fan on/off Fan speed Increase Unit power on/off Air Conditioner Controls Remote Control Controls The air conditioner controls are located behind the control panel door. Press to open and close the door. NOTE: The remote control will work with the control panel door open or closed. Power Pad Turns air conditioner on and off. When turned on, the display will show the room temperature. Display Shows the room temperature or time remaining on the Delay timer. Shows the Set temperature while setting the temperature in Cool or Energy Saver modes. The Set light will turn on while setting. NOTE: The display will change to show the room temperature after settings have been made. To recall the Set temperature, press the Temp Increase v or Decrease w pads. Mode Pad Use to set the air conditioner to Cool, Energy Saver or Fan Only mode. Delay Pads Delay ON-When the air conditioner is off, it can be set to automatically come on in 1 to 24 hours at its previous mode and fan settings. Delay OFF-When the air conditioner is on, it can be set to automatically turn off in 1 to 24 hours. How to set: Press the Delay 1-24hr pad on the unit or the pad on the remote control. Each touch of the Increase v / Decrease w pads on the unit or the Increase + / Decrease - pads on the remote control will set the timer in 1-hour intervals. The Set light will turn on while setting. Temp Increase v /Decrease w Pads To review the remaining time on the Delay Use to set temperature when in Cool or Energy 1-24hr timer, press the Delay 1-24hr pad on the Saver mode. The Set light will turn on while unit or the pad on the remote control. Use setting. the Increase v / Decrease w pads on the unit Delay Timer Increase v (+) /Decrease w (-) Pads or the Increase + / Decrease - pads on the remote control to set a new time if desired. Each touch of the Increase v / Decrease w To cancel the timer, press the Delay 1-24hr pad pads on the unit or the Increase + / Decrease - until the light on the Delay 1-24hr pad goes off. pads on the remote control will set the delay time when using the Delay 1-24hr timer ( ). The Set light will turn on while setting. CIRCULAIRE Pad Turn on to provide continuous side-to-side air circulation. Fan Speed Pads Use to set the fan speed to Low, Med, High or Auto on the unit. NOTE: On the remote control, use the fan speed Increase + / For fixed side-to-side air direction, turn on until the desired air direction is obtained, then turn it off. Decrease - pads to set the fan speeds to Low, Med or High. Use the Auto pad to turn Auto fan on. 4 Troubleshooting Tips Consumer Support