GE ASM10AL Owners Manual - Page 13

Window Installation Instructions [] INSTALL THE CASE IN THE WINDOW [] Cut the window sash seal to the window width and stick the adhesive side to the bottom of the sash. Window sill Window sash seal [] Thread two type C bolts into the support brackets. Slide the case into the window and lower the window behind the top mounting rail. Position the brackets on the case bottom so they will be near the outermost point on the window sill. Attach the support brackets to each side of the case bottom using 4 type A screws on each side. Adjust the leveling bolts to touch the sill. __ ,Type A screws Window sill -- =-. ln- _"_"-Type C bolts CAUTION: Ifthesillsupport bolts do not contact the window sill, or if you have a window without a sill, you must order accessory kit RAK87 to properly install this air conditioner. Call 800.626.2002 or visit ge.com. [] INSTALL THE CASE IN THE WINDOW (cont.) [] Locate the 7 screw holes along the bottom front edge of the case. Center the case, sideto-side, in the window and mount it to the window sill using 3 type B screws staggered in the front and back rows if possible. Top mounting rail screws Type B screws [] Extend the left and right accordion panels to the vertical window sashes and attach with 4 type B screws. [] INSTALL THE SECURITY BRACKET AND THE FOAM TOP WINDOW GASKET [] Attach the security bracket with a type B screw. [] Cut the foam top window gasket to the window width. [] Stuff the foam between the glass and the window to prevent air and insects from getting into the room. j/ 13