GE C2S980S Use and Care Manual - Page 45
Installation, Instructions, Connect the Range to the Gas Supply, DO NOT USE
View all GE C2S980S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
Safety Instructions Operating Instructions Read these instructions completely and carefully. Connect the Range to the Gas Supply Shut off the main gas supply valve before disconnecting the old range and leave it off until the new hookup has been completed. Don't forget to relight the pilot on other gas appliances when you turn the gas back on. Because hard piping restricts movement of the range, the use of a CSA International-certified flexible metal appliance connector is recommended unless local codes require a hard-piped connection. Never use an old connector when installing a new range. If the hard piping method is used, you must carefully align the pipe; the range cannot be moved after the connection is made. To prevent gas leaks, put pipe joint compound on, or wrap pipe thread tape with Teflon* around, all male (external) pipe threads. Install a manual gas line shut-off valve in the gas line in an easily accessed location outside of the range. Make sure everyone operating the range knows where and how to shut off the gas supply to the range. Install male 1/2″ flare union adapter to the 1/2″ NPT internal thread elbow at inlet of regulator. Use a backup wrench on the regulator fitting to avoid damage. When installing the range from the front, remove the 90° elbow for easier installation. Install male 1/2″ or 3/4″ flare union adapter to the NPT internal thread of the manual shut-off valve, taking care to backup the shut-off valve to keep it from turning. Connect flexible metal appliance connector to the adapter on the range. Position range to permit connection at the shut-off valve. When all connections have been made, make sure all range controls are in the off position and turn on the main gas supply valve. Use a liquid leak detector at all joints and connections to check for leaks in the system. CAUTION : DO NOT USE A FLAME TO CHECK FOR GAS LEAKS. When using test pressures greater than 1/2 psig to pressure test the gas supply system of the residence, disconnect the range and individual shut-off valve from the gas supply piping. When using test pressures of 1/2 psig or less to test the gas supply system, simply isolate the range from the gas supply system by closing the individual shut-off valve. *Teflon: Registered trademark of DuPont Installation Instructions Flexible Connector Hookup Rigid Pipe Hookup Options Troubleshooting Tips Consumer Support Pressure regulator Adapter Installer: Inform the consumer of the location of the gas shut-off valve. 1/2″ or 3/4″ Gas pipe Gas Flow into Range 45° Elbow Gas Flow into Range 90° Elbow Flex connector (6 ft. max.) Adapter Gas shut-off valve Nipple Black iron pipe Pressure regulator Union Installer: Inform the consumer of the location of the gas shut-off valve. Alternate Hookup Adapter Union Nipple Gas shut-off valve 1/2″ or 3/4″ Gas pipe 90° Elbow Nipple Gas shut-off valve 90° Elbow Nipple Quick connect or union Nipple Pressure regulator 90° Elbow 1/2″ or 3/4″ Gas pipe 90° Elbow Installer: Inform the consumer of the location of the gas shut-off valve. Adapter Gas Flow into Range 45