GE C2S980S Use and Care Manual - Page 52

Anti-tip Device, Lp, Make Sure All Controls Are Left In The, Off Position.

Get GE C2S980S - Cafe 30 in. Dual-Fuel Range PDF manuals and user guides View all GE C2S980S manuals
Add to My Manuals
Save this manual to your list of manuals

Page 52 highlights

Operating Instructions Safety Instructions Installation of the range. Anti-Tip Device Installation To reduce the risk of tipping the range, the range must be secured by a properly installed anti-tip bracket. See installation instructions shipped with the bracket for complete details before attempting to install. To check if the bracket is installed and engaged properly, remove the storage drawer or kick panel and look underneath the range to see that the leveling leg is engaged in the bracket. On models without a storage drawer or kick panel, carefully tip the range forward. The bracket should stop the range within 4 inches. If it does not, the bracket must be reinstalled. If the range is pulled from the wall for any reason, always repeat this procedure to verify the range is properly secured by the anti-tip bracket. Never completely remove the leveling legs or the range will not be secured to the anti-tip device properly. If you did not receive an anti-tip bracket with your purchase, call 1.800.626.8774 to receive one at no cost. (In Canada, call 1.800.561.3344.) For installation instructions of the bracket, visit www.GEAppliances.com. (In Canada, www.GEAppliances.ca.) When All Hookups Are Completed: MAKE SURE ALL CONTROLS ARE LEFT IN THE OFF POSITION. MAKE SURE THE FLOW OF COMBUSTION AND VENTILATION AIR TO THE RANGE IS UNOBSTRUCTED. Converting to LP Gas (or converting back to natural gas from LP) This range leaves the factory set for use with natural The conversion instructions and LP orifices can gas. If you want to convert to LP gas, the conversion be found attached to the range next to the must be performed by a qualified LP gas installer. pressure regulator. Keep these instructions and the orifices in case you want to convert back to natural gas. Installation Instructions Consumer Support Troubleshooting Tips 52

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
52
Anti-Tip Device Installation
To reduce the risk of tipping the range, the range
must be secured by a properly installed anti-tip
bracket. See installation instructions shipped with
the bracket for complete details before attempting
to install.
To check if the bracket is installed and engaged
properly, remove the storage drawer or kick panel
and look underneath the range to see that the
leveling leg is engaged in the bracket. On models
without a storage drawer or kick panel, carefully
tip the range forward. The bracket should stop
the range within 4 inches. If it does not, the
bracket must be reinstalled. If the range is pulled
from the wall for any reason, always repeat this
procedure to verify the range is properly secured
by the anti-tip bracket. Never completely remove
the leveling legs or the range will not be secured
to the anti-tip device properly.
If you did not receive an anti-tip bracket with
your purchase, call 1.800.626.8774 to receive
one at no cost. (In Canada, call 1.800.561.3344.)
For installation instructions of the bracket, visit
www.GEAppliances.com. (In Canada,
www.GEAppliances.ca.)
When All Hookups Are Completed:
MAKE SURE ALL CONTROLS ARE LEFT IN THE
OFF POSITION.
MAKE SURE THE FLOW OF COMBUSTION
AND VENTILATION AIR TO THE RANGE IS
UNOBSTRUCTED.
Converting to LP Gas
(or converting back to natural gas from LP)
This range leaves the factory set for use with natural
gas. If you want to convert to LP gas, the conversion
must be performed by a qualified LP gas installer.
The conversion instructions and LP orifices can
be found attached to the range next to the
pressure regulator.
Keep these instructions and the orifices in case
you want to convert back to natural gas.
Installation of the range.
Operating Instructions
Safety Instructions
Installation
Instructions
Troubleshooting Tips
Consumer Support