GE GLDT696TSS Installation Instructions - Page 6
Installation Instruction
UPC - 084691211785
View all GE GLDT696TSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Installation Instruction STEP 2 - ADJUST LEVELING LEGS •Move the dishwasher close to the installation location and lay it on its back. AdjAudsjtutsot to InstIanslltaatlilaotnion HeigHhetight STEP 4 - INSTALL POWER CORD Skip this step if dishwasher will be direct wired. The power cord and connections must comply with the National Electrical Code, Section 422and/or local codes and ordinances. Recommended power cord length is 54" min. and 64" max. A Remove Junction Box Cover B Check That White, Black and Green Dishwasher Wires Are Threaded Thru Hole in Back Ground White Black Figure 8 •Measure installation height and dishwasher height. Extend leveling legs out from the dishwasher base, 1/4"less than installation height. STEP 3 - REMOVE TOEKICK •Remove the 2 toekick screws. Lift off the 2 piece toekick. Figure 9 2-Screws D Use UL Listed Wire Nuts Figure 10 C Insert Power Cord Wires Thru Strain Relief and Tighten Connect incoming power cord white (or ribbed) to dishwasher white. Black (or smooth) to black. Ground to dishwasher green wire. Use UL listed wire nuts of appropriate size. Replace junction box cover . Be sure wires are not pinched under the cover . STEP 5 - INSTALL 90° ELBOW Wrap 90 elbow with thread seal tape. Install a 90 elbow onto the water valve. Fill Hose 90 Elbow Figure 11 Thread Seal Tape Water Valve Bracket •Do not over Tighten 90° elbow, water valve bracket could bend or water valve fitting could break. •Position the end of the elbow to face the rear of the dishwasher . 6