GE GTDP740GDWW Use and Care Manual - Page 12

About reversing the door. Reversing the Door Tools needed: „ Standard #2 Phillips screwdriver „ Tape-tipped putty knife „ Small flat blade screwdriver Before you Start Unplug the dryer from its electrical outlet. 3 Loosen the bottom 2 right side hinge screws. Remove the door and place it on a protected flat surface to avoid any damage. Remove both the Blind Plate and the Strike Plate and install them in opposite positions. Blind plate Inner door 1 Open the door approximately 170 degrees. With a putty knife, remove the 4 plastic covers located along the left side of the front panel and set them aside. Plastic Cover (4) Strike plate 4 Remove the 4 door hinge screws, 8 edge screws, and 4 inside screws. Lift the inner door upwards using a flat blade screwdriver. Inside screws Edge screws Inside screws Edge screws Left side of front panel 2 Remove the bottom screw from each hinge (right side) and partially insert them into the top left side hinge holes. NOTE: All 4 front panel hinge screws will now be in the top hinge holes - 2 on the left and 2 on the right. Door hinge screws Inner door Outer door Edge screws 12