GE GTW330ASKWW Installation Instructions - Page 23

GEAppliances.com PERFORMANCE Possible Causes What To Do Clothes too wet No spin selected Select a spin option. Incorrect cycle selected Wash load out of balance Make sure the cycle selected matches the load you are washing. Some fabrics will feel wetter when rinsed with cold water. Redistribute load in washer and run through Drain & Spin cycle. Blinking Spin light or Spin light on at end of cycle Pilling Snags, holes, tears, rips or excessive wear Wrinkling Out of balance condition has been detected Result of normal wear on poly-cotton blends and fuzzy fabrics Pins, snaps, hooks, sharp buttons, belt buckles, zippers and sharp objects left in pockets Undiluted chlorine bleach Chemicals like hair bleach or dye, permanent wave solution Incorrect wash and dry cycles Improper sorting Overloading Repeated washing in water that is too hot Allow cycle to continue and finish. If load is wet at the end of the cycle, even out load and run a Drain & Spin cycle. While this is not caused by the washer, you can slow the pilling process by washing garments inside out. Fasten snaps, hooks, buttons and zippers. Remove loose items like pins, objects in pockets and sharp buttons. Turn knits (which snag easily) inside out. Check bleach package instructions for proper amount. Never add undiluted bleach to wash or allow clothes to come in contact with undiluted bleach. Rinse items that may have chemicals on them before washing. Use Speed Wash cycle with Extra Rinse option. Match Cycle selection to the type of fabric you are washing (especially for easy care loads). Avoid mixing heavy items (like jeans) with light items (like blouses). Try a fabric softener. Loosely load clothes in the washer basket. Wash in warm or cold water. 23