GE JB700DNWW Use and Care Manual - Page 35
Safety Instructions, Operating, Instructions, Care and Cleaning, Consumer Support
UPC - 084691179412
View all GE JB700DNWW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
Safety Instructions GEAppliances.com Operating Instructions Care and Cleaning Troubleshooting Tips Consumer Support Problem Storage drawer is crooked Possible Causes Rear drawer support is on top of the guide rail. What To Do • Reposition the drawer. See the Storage Drawer Removal instructions in the Care and cleaning of the range section. Storage drawer won't close Power cord may be obstructing drawer in the lower back of the range. Rear drawer support is on top of the guide rail. • Reposition the drawer and power cord. See the Storage Drawer Removal instructions in the Care and cleaning of the range section. • Reposition the drawer. See the Storage Drawer Removal instructions in the Care and cleaning of the range section. Oven will not self-clean The oven temperature is too high to set a self-clean operation. • Allow the oven to cool to room temperature and reset the controls. Oven controls improperly set. • See the Using the self-cleaning oven section. Oven door is not in the locked • Make sure you move the door latch handle all the position. way to the right. "Crackling" or "popping" sound This is the sound of the metal heating and cooling during both the cooking and cleaning functions. • This is normal. Excessive smoking Excessive soil. during a clean cycle • Touch the Clear/Off pad. Open the windows to rid the room of smoke. Wait until the light on the Self Clean pad goes off. Wipe up the excess soil and reset the clean cycle. Oven door will not unlock Oven too hot. • Allow the oven to cool below locking temperature. Oven not clean after a clean cycle Oven controls not properly set. • See the Using the self-cleaning oven section. Oven was heavily soiled. • Clean up heavy spillovers before starting the clean cycle. Heavily soiled ovens may need to self-clean again or for a longer period of time. "F -" and a number or letter flash in the display You have a function error code. • Disconnect all power to the range for at least 30 seconds and then reconnect power. If the function error code repeats, call for service. • On self-cleaning models, if a function error code appears during the self-cleaning cycle, check the oven door latch. The latch may have been moved, if only slightly, from the locked position. Make sure the latch is moved to the right as far as it will go. Touch the Clear/Off pad. Allow the oven to cool for one hour. Put the oven back into operation. Water remaining on oven floor after Steam Clean cycle This is normal. • Remove any remaining water with a dry cloth or sponge. 35