GE JGP940SEKSS Installation Instructions - Page 14
ConT. - model
UPC - 084691114437
View all GE JGP940SEKSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Installation Instructions Making the LP Conversion (CONT.) 3 Change Cooktop Burner Orifices A Remove the top grates, burner caps, and burner heads. Remove This Assembly B Remove the spark igniters from the burner base (if required to access the orifices). Using a No. 15 "Torx" head driver bit, remove the screws holding the Orifice Spud Located burner base in position. Through This Opening C Using a 7mm nut driver, remove the top burner orifices. These may be accessed through the hole in the cooktop. Burner cap Burner head 3 Change Cooktop Burner Orifices (CONT.) NOTE: On most burners, the orifices have a springloaded retaining ring around Retainer Ring the hex head to hold the orifice in the nut driver during installation and removal. A slight amount of force is required to push the nut driver down over the ring. Spark igniter Burner base 18,000 BTU Burner (on some models) Burner base Burner cap Burner head Spark igniter 14