GE JT965SKSS Installation Instructions - Page 1

GE JT965SKSS Manual

Page 1 highlights

Installation Instructions 30" Built-In Wall Oven with Microwave JTP86, JT965 If you have questions, call 1.800.GE.CARES or visit our website at: ge.com Before You Begin Read these instructions carefully and completely. • IMPORTANT-Save these instructions for local inspector's use. • IMPORTANT-Observe all governing codes and ordinances. • Note to Installer-Be sure to leave these instructions with the consumer. • Note to Consumer-Keep these instructions for future reference. • Proper installation is the responsibility of the installer and product failure due to improper installation is NOT covered under warranty. • NOTE-This appliance must be properly grounded. • ATTENTION INSTALLER All electric wall ovens must be hard wired (direct wired) into an approved junction box. A plug and receptacle is NOT permitted on these products. Parts Included Metal Bottom Trim Screws For Installation Plastic Bottom Trim Materials Needed Strain Relief Clamp for 1/2" conduit Junction Box Wire Nuts 36" of String Optional Metal Bottom Trim Assembly (on some models) Tools Needed 1/8" Drill Bit and Electric or Hand Drill Phillips Screwdriver 31-10660 1-07 JR 1

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12

1
If you have questions, call 1.800.GE.CARES or visit our website at:
ge.com
30
Built-In Wall Oven
with Microwave
Installation
Instructions
JTP86, JT965
Before You Begin
Read these instructions carefully and completely.
IMPORTANT
—Save these
instructions for local inspector’s use.
IMPORTANT
—Observe all
governing codes and ordinances.
Note to Installer—Be sure to leave these
instructions with the consumer.
Note to Consumer—Keep these
instructions for future reference.
Proper installation is the responsibility
of the installer and product failure due
to improper installation is NOT covered
under warranty.
NOTE—This appliance must be properly
grounded.
ATTENTION INSTALLER
All electric wall ovens must be hard wired
(direct wired) into an approved junction
box. A plug and receptacle is NOT permitted
on these products.
Materials Needed
Strain Relief Clamp
for 1/2
conduit
Junction
Box
Wire Nuts
36
of String
31-10660
1-07 JR
Tools Needed
1/8
Drill Bit and
Electric or Hand Drill
Phillips
Screwdriver
Parts Included
Screws For
Installation
Metal
Bottom Trim
Plastic
Bottom Trim
Optional
Metal Bottom
Trim Assembly
(on some models)