GE JV348LSS Use and Care Manual - Page 11

Installation Instructions 8 FOR 31⁄4″ X 10″ RECTANGULAR DUCTED DISCHARGE INSTALLATIONS ONLY: Attach exhaust adaptor/damper over the appropriate knockout opening (for vertical or horizontal, depending on installation) with two exhaust adaptor screws. Make sure damper pivot is nearest to top/back edge of hood. Remove tape from damper flap. Exhaust adaptor/damper (vertical discharge position) Tape 10 FOR RECESSED-BOTTOM CABINETS ONLY Wood shims (minimum thickness 3/8″) • If the cabinets have front, side or back trim, make 2 wood shims a minimum of 3/8″ thick and cut to fit the width of the inner recessed cabinet bottom. Attach them to the cabinet bottom recess on both sides. See Step 11 for marking locations. Pivot (depending on installation) Top/back edge Exhaust adaptor/damper (horizontal discharge position) 9 FOR 7″ ROUND VERTICAL DUCTED DISCHARGE INSTALLATIONS ONLY: Bend up the duct alignment ears in preparation for later attachment of the 7″ duct. Attachment ear tabs 11