GE JVM1540SPSS Use and Care Manual - Page 35

Charcoal Filter, on some models, To Remove, To Install, cannot be cleaned. It, must be replaced. Order

Page 35 highlights

Charcoal Filter (on some models) The charcoal filter cannot be cleaned. It must be replaced. Order Part No. WB06X10823 from your GE supplier. To Remove Charcoal Filter Remove 3 grille screws to remove the grille. To Install Charcoal Filter If the model is not vented to the outside, the air will be recirculated through a disposable charcoal filter that helps remove smoke and odors. The charcoal filter should be replaced when it is noticeably dirty or discolored (usually after 6-12 months, depending on hood usage). See "Optional Kits," page 9, for more information. To remove the charcoal filter, disconnect power at the main fuse or circuit breaker panel or pull the plug. Remove the top grille by removing the 3 screws on top of the oven that hold the grille in place. Slide the grille to the left to remove it. Push the filter at the bottom until it comes free of the locking tabs. Slide the filter down and out. Filter housing To install a new filter, remove plastic and other outer wrapping from the new filter. Insert the filter into the left side of the front top opening of the oven as shown. It will rest at an angle on 2 side support tabs and in front of the right rear tab. Replace the grille and 3 screws. 35

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40

35
If the model is not vented
to the outside, the air will
be recirculated through a
disposable charcoal filter
that helps remove smoke
and odors.
The charcoal filter should
be replaced when it is
noticeably dirty or
discolored (usually after
6–12 months, depending
on hood usage). See
“Optional Kits,” page 9,
for more information.
The charcoal filter
cannot be cleaned. It
must be replaced. Order
Part No. WB06X10823
from your GE supplier.
Charcoal Filter
(on some models)
To remove the charcoal
filter, disconnect power
at the main fuse or circuit
breaker panel or pull
the plug.
Remove the top grille by
removing the 3 screws on
top of the oven that hold
the grille in place. Slide
the grille to the left to
remove it.
Push the filter at the
bottom until it comes free
of the locking tabs. Slide
the filter down and out.
To Remove
Charcoal Filter
Remove 3 grille screws
to remove the grille.
To install a new filter,
remove plastic and other
outer wrapping from the
new filter.
Insert the filter into the left
side of the front top
opening of the oven as
shown. It will rest at an
angle on 2 side support tabs
and in front of the right
rear tab. Replace the grille
and 3 screws.
To Install
Charcoal Filter
Filter housing