GE JX2127SH Installation Instructions - Page 1

Installation Instructions Built-In Trim Kits JX2127 and JX2130 Questions? Call GE Answer Center at 800.626.2000 or Visit our Website at: www.GEAppliances.com BEFORE YOU BEGIN Read these instructions completely and carefully. • IMPORTANT - Save these instructions for local inspector's use. • IMPORTANT - Observe all governing codes and ordinances. • Note to Installer - Be sure to leave these instructions with the Consumer. • Note to Consumer - Keep these instructions for future reference. • For easier installation and personal safety, we recommend that two people install this microwave oven. • Unplug the microwave oven before attempting installation of this kit. FOR YOUR SAFETY: WARNING - Before beginning the installation, switch power off at service panel and lock the service disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel. • Skill level - Installation of this appliance requires basic mechanical and electrical skills. • Completion time - 1-3 hours • Proper installation is the responsibility of the installer. • Product failure due to improper installation is not covered under the Warranty. • This kit is UL listed for installation alone or over any General Electric/Hotpoint/RCA single electric wall oven. PARTS INCLUDED PART Trim Frame QUANTITY 1 Bottom Duct 1 Top Bracket 1 TOOLS YOU WILL NEED #2 Phillips screwdriver Pencil Drill with 7⁄64″ bit or #35 Awl or punch Scissors (optional) Tape measure Phillips Round-Head Screws Phillips Flat-Head Screws Anti-Tip Bracket 24 (22 required for installation) 5 (4 required for installation) 1 Bottom Bracket 1 Template 1 READ CAREFULLY. KEEP THESE INSTRUCTIONS. 1