GE PDW7880RSS Use and Care Manual - Page 10

Safety Instructions About the dishwasher control panel. Choose the dishwasher control panel that corresponds to the features on your dishwasher. 16 Operating Instructions Troubleshooting Tips 3 5 4 2 Control Settings 1 Status Indicator Lights The Status display tells you what's happening while the dishwasher is in operation and may flash, indicating a malfunction (see page 6). The lights will come ON indicating the sequence of operation the dishwasher is in. LOW DETERGENT Displayed when the SmartDispenseTM needs to be refilled with liquid or gel automatic (on some models) dishwasher detergent. SENSING Displayed while the ExtraClean™ Sensor is measuring the amount of soil and temperature of water. The dishwasher will adjust the selected cycle to achieve optimal performance. WASHING Displayed during prewash and main wash periods. DRYING Displayed during HEATED DRY. SANITIZED Displayed when cycle has met sanitization conditions. Light remains ON until door is opened. CLEAN Displayed when a wash cycle is complete. 2 Time Remaining Display (on some models) During operation, the display shows the minutes remaining until the cycle is complete. The display may adjust the remaining time while the Sensing light is on. The time displayed at the start of each cycle may change from the factory setting as the unit customizes itself to home use. During a delay start, the display will show hours of time remaining until the cycle starts. 3 Cycles Press the pad for the desired wash cycle. NOTE: All cycle times and water usage information contained in the following section are approximate values only. Actual results will depend on several factors, including but not limited to, inlet temperature, household water pressure and turbidity of the wash water. The light above or next to the selected pad will be ON to indicate which WASH CYCLE has been selected. SANI WASH 7.5-8.75 gal., 50-135 min. This cycle raises the water temperature in the final rinse to sanitize your dishware. The cycle length will vary depending on the temperature of your inlet water. NOTE: The SANI WASH cycle is monitored for sanitization requirements. If the cycle is interrupted during or after the main wash portion or if the incoming water temperature is so low that adequate water heating cannot be achieved, the sanitizing conditions may not be met. In these cases, the Sanitized light will not illuminate at the end of the cycle. NOTE: NSF certified residential dishwashers are not intended for licensed food establishments. POTS & PANS 8.75-10 gal., 75-140 min. This cycle is meant for heavily soiled dishes or cookware with dried-on or baked-on soils. This cycle may not remove burned-on foods. Everyday dishes are safe to be used in this cycle. NORMAL WASH 5.2 gal., 60-90 min. This cycle is for medium/heavily soiled dishes and glassware. LIGHT WASH 7.5 gal., 40-60 min. (on some models) This cycle is for everyday dishes and glassware. 10 Consumer Support