GE PDW7880RSS Use and Care Manual - Page 21
Consumer Support, Operating Instructions, Safety Instructions, Problem, Possible Causes, What To
UPC - 084691224051
View all GE PDW7880RSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Safety Instructions GEAppliances.com Problem Possible Causes What To Do Control panel lights Time too long between go off when you're touching of selected pads setting controls Water standing in This is normal the bottom of the tub Water won't pump out of the tub Drain is clogged Steam This is normal Sanitized light does not illuminate at the end of the cycle (Anti-Bacteria cycle only) Noise The door was opened and the cycle was interrupted during or after the main wash portion The incoming water temperature was too low Normal operating sounds Detergent cup opening • Each pad must be touched within 30 seconds of the others. To relight, touch any pad again, or unlock and relatch door. • A small amount of clean water around the outlet on the tub bottom at the back of the tub keeps the water seal lubricated. • If you have an air gap, clean it. See page 18. • If the dishwasher drains into a disposer, run disposer clear. • Check to see if your kitchen sink is draining well. If not, you may need a plumber. • Warm, moist air comes through the vent by the door latch during drying and when water is being pumped out. This is necessary for drying. • Do not interrupt the cycle anytime during or after main wash. • Raise the water heater temperature to between 120°F and 140°F. • These are all normal. No action is required. Water entering dishwasher The motor stops and starts at various times during the cycle Drain pump sounds during pump out Rattling dishes when the spray • Make sure dishes are properly loaded. See the Loading the arm rotates dishwasher racks section. Operating Instructions Troubleshooting Tips Consumer Support 21