GE PGP9830SJSS Installation Instructions - Page 20

INSTALLATION INSTRUCTIONS Installation Instructions CABINET PREPARATION 1 PREPARING FOR INSTALLATION Positioning the cooktop The cooktop is designed to look best when centered in a cabinet at least 30" wide. The exhaust vent beneath the cooktop must be located between wall studs or floor joists so that the ductwork may be installed properly. 13" max. depth of unprotected overhead cabinets 30" min. clearance from countertop to unprotected overhead surface 18" min. height from countertop to nearest cabinet on either side of the unit 5" min. clearance from cutout to side walls The downdraft system with blower, motor and ductwork will occupy the cabinet below the cooktop. Drawers cannot be installed below this cooktop. Avoid placing cabinets above the cooktop unit, if possible, in order to reduce the hazards caused by reaching over heated surface units. If the cabinetry is used above the cooktop, allow a minimum 30" clearance between the cooking surface and the bottom of the unprotected cabinet. If the clearance between the cooktop and the cabinetry is less than 30", the cabinet bottom must be protected with a flame retardant millboard at least 1/4" thick, or gypsum board at least 3/16" thick, covered with 28 gauge sheet steel or 0.020" thick copper. Clearance between the cooktop and the protected cabinetry MUST NEVER BE LESS THAN 24 ". EXCEPTION: Installation of a listed microwave oven or cooking appliance over the cooktop shall conform to the installation instructions packed with that appliance. Working areas adjacent to the cooktop should have an 18" minimum clearance between the countertop and the bottom of the cabinet. If the clearance is less than 18", the adjacent cabinets should be at least 5" from the side edge of the cooktop. 2 PREPARING THE BASE CABINET This cooktop is designed to fit easily into a variety of cabinets. However, the combined installation of a downdraft vent and a cooktop require careful consideration. Some cabinets may require modifications. This installation requires a 24" min. deep cabinet base. The cabinet must be at least 30" wide. Preparing a cabinet that is against a wall In some cabinets, the sides may need to be scooped or cut down 53ø4" as shown, and the corner braces removed in order to accommodate the unit. In 75 cm and 90 cm frameless European cabinets, the back panel may need to be cut down 53ø4" to accommodate the unit. Preparing a peninsula or island-type cabinet In a peninsula or island type cabinet, the sides may need to be scooped or cut down, and the corner braces removed in order to accommodate the unit. 53ø4" Approx. 53ø4" Approx. for European cabinets 20 49-80516-4