GE PHS930BLTS Use and Care Manual - Page 23

Care And Cleaning

Get GE PHS930BLTS PDF manuals and user guides View all GE PHS930BLTS manuals
Add to My Manuals
Save this manual to your list of manuals

Page 23 highlights

CARE AND CLEANING:&OHDQLQJWKH*ODVV&RRNWRS2YHQ3UREH Cleaning the Glass Cooktop (Cont.) Metal Marks and Scratches 1. Be careful not to slide pots and pans across your cooktop. It will leave metal markings on the cooktop surface. These marks are removable using the CERAMA BRYTE® Ceramic Cooktop Cleaner with the CERAMA BRYTE® Cleaning Pad for Ceramic Cooktops. 2. If pots with a thin overlay of aluminum or copper are allowed to boil dry, the overlay may leave black discoloration on the cooktop. This should be removed immediately before heating again or the discoloration may be permanent. NOTE: Carefully check the bottom of pans for roughness that would scratch the cooktop. Damage from Sugary Spills and Melted Plastic Special care should be taken when removing hot substances to avoid permanent damage of the glass surface. Sugary spillovers (such as jellies, fudge, candy, syrups) or melted plastics can cause pitting of the surface of your cooktop (not covered by the warranty) unless the spill is removed while still hot. Special care should be taken when removing hot substances. Be sure to use a new, sharp razor scraper. 'RQRWXVHDGXOORUQLFNHGEODGH 1. Turn off all surface units. Remove hot pans. 2. Wearing an oven mitt:   D 8VHDVLQJOHHGJHUD]RUEODGHVFUDSHUWRPRYH the spill to a cool area on the cooktop. b. Remove the spill with paper towels. 3. Any remaining spillover should be left until the surface of the cooktop has cooled.  'RQ¶WXVHWKHVXUIDFHXQLWVDJDLQXQWLODOORIWKH residue has been completely removed. NOTE: If pitting or indentation in the glass surface has already occurred, the cooktop glass will have to be replaced. In this case, service will be necessary. Oven Probe The temperature probe may be cleaned with soap and water or a soap-filled scouring pad. Cool the temperature probe before cleaning. Scour stubborn spots with a soapfilled scouring pad, rinse and dry. To order additional temperature probes, see the Accessories and Consumer Support sections at the end of this manual. Ŷ 'RQRWLPPHUVHWKHWHPSHUDWXUHSUREHLQZDWHU Ŷ 'RQRWVWRUHWKHWHPSHUDWXUHSUREHLQWKHRYHQ Ŷ 'RQRWOHDYHWKHWHPSHUDWXUHSUREHLQVLGHWKHRYHQ during a self or steam clean cycle. 49-80806 23

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
49-80806
23
Metal Marks and Scratches
1. Be careful not to slide pots and pans across your
cooktop. It will leave metal markings on the cooktop
surface.
These marks are removable using the CERAMA
BRYTE
®
Ceramic Cooktop Cleaner with the CERAMA
BRYTE
®
Cleaning Pad for Ceramic Cooktops.
2.
If pots with a thin overlay of aluminum or copper
are allowed to boil dry, the overlay may leave black
discoloration on the cooktop.
This should be removed immediately before heating
again or the discoloration may be permanent.
NOTE:
Carefully check the bottom of pans for roughness
that would scratch the cooktop.
Damage from Sugary Spills and Melted Plastic
Special care should be taken when removing hot substances
to avoid permanent damage of the glass surface
.
Sugary spillovers (such as jellies, fudge, candy, syrups) or melted plastics can cause pitting of the surface of your
cooktop (not covered by the warranty) unless the spill is removed while still hot. Special care should be taken when
removing hot substances.
Be sure to use a new, sharp razor scraper.
1.
Turn off all surface units. Remove hot pans.
2.
Wearing an oven mitt:
the spill to a cool area on the cooktop.
b.
Remove the spill with paper towels.
3.
Any remaining spillover should be left until the surface
of the cooktop has cooled.
residue has been completely removed.
NOTE:
If pitting or indentation in the glass surface has
already occurred, the cooktop glass will have to be
replaced. In this case, service will be necessary.
Cleaning the Glass Cooktop (Cont.)
CARE AND CLEANING:
Oven Probe
The temperature probe may be cleaned with soap and
water or a soap-filled scouring pad. Cool the temperature
probe before cleaning. Scour stubborn spots with a soap-
filled scouring pad, rinse and dry.
To order additional temperature probes, see the
Accessories and Consumer Support sections at the end
of this manual.
during a self or steam clean cycle.