GE PP989TNWW Use and Care Manual - Page 24

Installation Instructions INstalling the cooktop 14 Attaching A Blower Transition Duct Use a blower transition duct for all downward duct installations to connect to 6" round standard ductwork. This 31⁄4" x 10" rectangle to 6≤ round transition duct is available at your local building supply store. 16 BLOWER Electrical connections (cont.) • Connect the 5-pin plug on the blower assembly to the matching 5-pin receptacle on the bottom of the wire enclosure. • Screws Screw (on other side) 5-pin connectors Remove the cardboard packing in the blower outlet. Install the transition duct to the blower outlet. Secure all joints with duct tape to assure an airtight seal. Fold all wires into the electrical enclosure. Secure the enclosure with the screws removed earlier, making sure that no wires are trapped. 15 Connecting the Ductwork Connect the ductwork prepared in Steps 5 and 6 to the blower transition duct. 16 BLOWER Electrical connections • Loosen the two screws and remove and discard the sheet metal strap covering the 5-pin connector on the cooktop bottom. Save the screws for reinstallation later. 5-pin connectors Electrical enclosure Flexible conduit Remove screws and discard strap 24