GE PSB1000NWW Installation Instructions - Page 1

Installation Instructions Profile Advantium™ 120 Built-In SpeedCook Ovens PSB1000 PSB1001 Questions? Call 800.GE.CARES (800.432.2737) or visit our Website at: GEAppliances.com BEFORE YOU BEGIN Read these instructions completely and carefully. • IMPORTANT - Save these instructions for local inspector's use. • IMPORTANT - Observe all governing codes and ordinances. • Note to Installer - Be sure to leave these instructions with the Consumer. • Note to Consumer - Keep these instructions for future reference. • Skill level - Installation of this appliance requires basic mechanical and electrical skills. • Completion time - 1 hour • Proper installation is the responsibility of the installer. • Product failure due to improper installation is not covered under the Warranty. See Owner's Manual for warranty information. IMPORTANT: • Use this oven only for its intended purpose. • Never use the oven for warming or heating a room. Prolonged use of the oven without proper ventilation can be hazardous. CAUTION: For personal safety, remove house fuse or oven circuit breaker before beginning installation to avoid severe or fatal shock injury. CAUTION: For personal safety, the mounting surface must be capable of supporting the cabinet load, in addition to the added weight of the 75-pound product, plus additional oven loads of up to 50 pounds or a total weight of 125 pounds. CAUTION: For personal safety this product cannot be installed in cabinet arrangements such as an island, a peninsula or below a countertop. For a Spanish version of this manual, visit our Website at GEAppliances.com. Para consultar una version en español de este manual de instrucciones, visite nuestro sitio de internet GEAppliances.com. CONTENTS Design Information Models Available 2 Product Dimensions and Clearances 2 Tools Required 2 Parts Supplied 2 Advance Planning 3 Installation Preparation Electrical Requirements 4 Prepare the Opening 5, 6 Remove the Packaging 6 Installation Instructions Step 1, Slide the Oven into the Cutout 7 Step 2, Install Bottom Trim 7 Step 3, Install Mounting Screws 8 Step 4, Finalize Installation 8 MFL59060902 49-40607 02-09 JR