GE PVM9215SKSS Installation Instructions - Page 13

Installation Instructions A2. USE TOP CABINET TEMPLATE FOR PREPARATION OF TOP CABINET You need to drill holes for the top support screws, a hole large enough for the power cord to fit through, and a cutout large enough for the exhaust adaptor. A4. ADAPTING BLOWER FOR OUTSIDE VENTILATION (Cont.) • Read the instructions on the TOP CABINET TEMPLATE. • Tape it underneath the top cabinet. • Drill the holes, following the instructions on the TOP CABINET TEMPLATE. CAUTION Wear safety goggles when drilling holes in the cabinet bottom. 3 Attached the metal blower shield to the backside of the microwave oven by sliding it down. Blower Shield 4 Open the blower door by lifting it up at the back of the microwave oven. A3. CHECK BLOWER MOTOR ORIENTATION The blower fan blade opening should be facing the top of the microwave. If the fan opening is already facing the top of the microwave, skip to Step A5. Otherwise, continue to Step A4 to adjust the motor orientation. 5 Carefully pull out the blower unit. The wires will extend far enough to allow you to adjust the blower unit. BEFORE: Fan Blade Openings Facing Forward A4. ADAPTING BLOWER FOR OUTSIDE VENTILATION 1 Remove and save the screws that hold the blower motor to the microwave oven. Blower Motor Screw Blower Plate Back of Oven Blower Motor Screws 2 Remove and save the metal blower shield on the top of the microwave by sliding it right. 6 5ROOWKHEORZHUXQLWÛVRWKDWWKHIDQEODGH openings are facing the top. AFTER: Fan Blade Roll Openings Facing Up NOTE: Make sure wires remain routed in the grooves of the motor frame. 13