GE PVM9215SKSS Installation Instructions - Page 7

Installation Instructions TOOLS YOU WILL NEED # 1 and #2 Phillips screwdriver Pencil Ruler or tape measure and straight edge Carpenter square (optional) Tin snips (for cutting damper, if required) Gloves Scissors (to cut template, if necessary) Electric drill with 3ø16s, 1ø2s and 5ø8s drill bits Filler blocks or scrap wood pieces, if needed for top cabinet spacing (used on recessed bottom cabinet installations only) Saw (saber, hole or keyhole) Stud finder or Hammer (optional) Safety goggles Level Duct and masking tape MOUNTING SPACE 13s max*. 161ø2s 30s 2s 66s or More from the Floor to the Top of the Microwave Bottom Edge of Cabinet Needs to be 30s or More from the Cooking Surface 30s min. Backsplash Minimum distance from door hinge side to adjacent wall should equal 3/4" NOTES: • The space between the cabinets must be 30s wide and free of obstructions. • If the space between the cabinets is greater than 30s, a Filler Panel Kit may be used to fill in the gap between the microwave oven and the cabinets. Your Owner's Manual contains the kit number for your model. • This microwave oven is for installation over ranges up to 36s wide. • If you are going to vent your microwave oven to the outside, see Hood Exhaust Section for exhaust duct preparation. • When installing the microwave oven beneath smooth, flat cabinets, be careful to follow the instructions on the top cabinet template for power cord clearance. • Models with top venting grilles: Do not allow cabinetry or other objects to block the airflow of the vent. * 13" max: for standard installation, 15" cabinet depth requires additional steps using an additional installation kit JX15BUMPWW/BB. 7