GE SCA1000 Installation Instructions - Page 22
Installing the Charcoal Filter
View all GE SCA1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Installation Instructions C5. MOUNT THE OVEN (continued) 5 Insert 2 self-aligning screws (1⁄4″-28 x 31⁄4″) through outer top cabinet holes. Turn two full turns on each screw. C6. INSTALLING THE CHARCOAL FILTER 1 Remove 2 screws on top of oven, just above the grille panel, using a Phillips screwdriver. Remove one screw on the left side. 2 Open the door. 3 Remove the grille. Screws 6 Tighten center screw completely. NOTE: Use self-aligning screw, 1⁄4″-28 x 25⁄8″, on JVM1790 and self-aligning screws, 1⁄4″-28 x 31⁄4″, on JVM1490, SCA1000, and SCA1001. 7 Tighten the outer two screws to the top of the oven. (While tightening screws, hold the oven in place against the wall and the top cabinet.) Side Screw 4 Insert the filter into the oven as shown, maneuvering it behind the plastic grille until it fits squarely into place. It will rest at an angle behind the plastic grille on two side support tabs and in front of the right rear tab. When properly installed, the wire mesh of the filter should be visible from the front. 8 Install grease filters. See the Owner's Manual packed with the oven. 5 Replace the grille and the 2 top screws. 6 Close the door and replace left side screw. Insert mesh-side down 22