GE WPGT9150HMG Owners Manual - Page 6

Operating Instructions Safety Instructions About the washer features. NOTE: Features may not be available on all washer models. Cycle Signal Use the SIGNAL button to change the volume of the end of cycle signal. Press the button until you reach the desired volume. Soak Soak is an extra wash before the main wash. Use it for heavily soiled clothes or for clothes with a care label that recommends soaking before washing. Be sure to add high-efficiency detergent, or the proper wash additive to the soak dispenser. NOTES: • When selecting soak, it is recommended to use powder detergent in the main wash (detergent) compartment . • The maximum soak time is 3 hours. Extra Rinse Use an extra rinse when additional rinsing is desired to remove excess dirt and detergent from soiled loads. Delay Start You can delay the start of a wash cycle for up to 24 hours. Press the DELAY START button to choose the number of hours you want to delay the start of the cycle, then press the START button. The machine will count down and start automatically at the correct time. NOTE: If you open the lid when the delay is counting down, the machine will enter the pause state. You must close the lid and press START again in order to restart the countdown. MY CYCLE To save a favorite cycle, set the desired settings for wash cycle, soil level, spin speed and wash temp settings and hold down the MY CYCLE button for 3 seconds. A beep will sound to indicate the cycle has been saved. To use your custom cycle, press the MY CYCLE button before washing a load. To change the saved cycle, set the desired settings and hold down the MY CYCLE button for 3 seconds. NOTE: When using MY CYCLE, wash options cannot be modified after the cycle has been started. NOTE: If you change wash options with MY CYCLE before starting the cycle, the MY CYCLE light will turn off and you will be returned to the base cycle. Installation Instructions Consumer Support Troubleshooting Tips 6