GE asd06lk Owners Manual - Page 4

About the controlson the air conditionermmodels with touchpads. Features and appearance will vary. COOLOft ENE£GY SAVE£ On SLEEPOn @ @ @ Air ConditionerControls Remote Control G ) TOunrn/Osffair conditioner on and off. O DDiisspplalaysy tile set temperature or time remaining on fime_: @Mode Use to set tile air conditioner to Cool or Fan I/lode. O Increase •/Decrease • Pads Use to set temperature when in Cool mode. 0 Fan Use to set tile tim speed at Low, Medor High. o girculaire (on some models) TtlYn on to provide air circulation. ('ontintlOtlS side-to-side For fixed side-to-side air direction, mrn On until the desired air direction is obtained, then mrn it Off. O Energy Saver-Controls tile tim. On--The tilll and compressor cycle on and off. This results in wider \miations of room temperature and humidit,i. Nommlly used when the room is tmoccui)ied. Note: The fan will continue to run for a short time after the compressor cycles oK O/'/JThe tiln rtlns all tile time, while tile compressor cycles on and otE This switch must be set at O//in order to use the tim settings (on the mode control). Timer On--X,Vhen tile air conditioner is off, it can be set to automatically mrn on in 1 to 24 hom_ at its i)revious setting. Each touch will set tile time in hom_. O/'/J]'_ hen tile air conditioner is on, it can be set to automatically turn off in 1 to 24 hou_. Each touch will set tile time in hom_. To cancel tile timex; press tile Timerpad tmtil tile display time disappears. Sleep (on some models) Press to set tile air conditioner 8 ho/u_ befi)re it automatically to run fi)r shuts off'. One hour after tile sleep timer is set, tile set temperature will automatically increase 2°F. To cancel the sleep mode, press the Sleep pad a second time. Note: Thesleep timer will be cancelled if the Timer,Energy Saver or Mode pad is pressed. 0 Remote Control Signal Receiver Remote Control To ensure proper operation, aim tile remote control at tile signal receixer on tile air conditione_: Make sure nothing is between tile air conditioner and the remote control that could block the signal. Tile remote control signal has a range of Make sure batteries are fl'esh and installed 4 up t ( ) c21 teet. correctly see the Care and Cleaning section.