GE zgu384nsmss Installation Instructions - Page 2

Safety Information BEFORE YOU BEGIN Read these instructions completely and carefully. • • - Save these instructions for local inspector's use. - Disconnect all electrical power at the main circuit breaker or fuse box before installing. WARNING IMPORTANT codes and ordinances. • Note to Installer - Be sure to leave these instructions with the Consumer. • Note to Consumer - Keep these instructions for future reference. • Product failure due to improper installation is not covered under the Warranty. properly grounded. • IMPORTANT - Observe all governing WARNING - This appliance must be - Leak testing of the appliance shall be conducted according to the manufacturer's instructions. • Proper installation is the responsibility of the installer and product failure due to improper installation is NOT covered under warranty. IMPORTANT This cooktop has been design certified by Underwriters Laboratories. You'll find safety precautions in your Owner's Manual. Read them carefully. • Installation of this cooktop must conform with local codes or, in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1/NFPA 54-Latest Edition. • Be sure your cooktop is installed properly by a qualified installer or service technician. • To eliminate reaching over surface burners, cabinet storage above burner should be avoided. • Do not install the unit near an outside door or where a draft may affect its use. IN THE COMMONWEALTH OF MASSACHUSETTS: • This product must be installed by a licensed plumber or gas fitter. • When using ball-type gas shut-off valves, they shall be the T-handle type. • A flexible gas connector, when used, must not exceed 3 feet. FOR YOUR SAFETY: - If the information in this manual is not followed exactly, a fire, explosion or gas leak may result, causing property damage, personal injury or death. Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance! WARNING WHAT TO DO IF YOU SMELL GAS: • Do not try to light any appliance. Do not touch any electrical switch; do not use any phone in your building. • Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions. • If you cannot reach your gas supplier, call the fire department. Installation and service must be performed by a qualified installer, service agency or the gas supplier. Be sure the installation of this product in a mobile home conforms with the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280. If this standard does not apply, you must follow the standard for Manufactured Home Installations, ANSI A225.1 and Manufactured Home Installations, Sites and Communities, ANSI/NFPA 501A or with local codes. You can get a copy of the Federal Standard by Writing: Office of Mobile Home Standards HUD Building 451 7th Street, S.W. Washington, D.C. 24010 2