Gigabyte 3D Mercury User Manual - Page 20

English 4-12-5-2 Connect the 3-pin power connector of the fan into the CPU fan socket on the motherboard (Fig. a: 3-pin CPU fan socket / Fig. b: 4-pin CPU fan socket (LGA775)) Fig. a Fig. b 4-12-6 Pump power Cable Installation. 4-12-6-1 Connect the power SW cord (female 2-pin) with the "+PW-" jumper on to the motherboard. 4-12-7 Adding coolant to the tank. Please remove the lid on the top of the chassis and check the coolant level gauge on the front panel of the chassis. Fill the tank to 80% full and close the lid. Turn on the power until all the coolant drains into the tubes. The system should shutdown automatically due to the tank coolant level being too low or empty. (This is normal as the tubes and radiator are not filled with liquid). Open the lid again and fill the tank up to 80% full; repeat this until all tubes and radiator are filled with coolant and the tank coolant level is constant at 80% full. 4-12-6-2 Connect the 4-pin connector from the pump to a 4-pin connector of the power supply. 4-13 4-way Splitter Valve Instruction and User Manual Note: Gigabyte Blue Eye and Chipset 20