Gigabyte AORUS MODEL X 11th User Manual - Page 7

Back View-A, Q-Flash Plus Button, Clear CMOS Button, SMA Antenna Connectors 2T2R

Get Gigabyte AORUS MODEL X 11th PDF manuals and user guides View all Gigabyte AORUS MODEL X 11th manuals
Add to My Manuals
Save this manual to your list of manuals

Page 7 highlights

Back View-A Q-Flash Plus Button (Note) This button allows you to update the BIOS when the power connector is connected but the system is not powered on. Clear CMOS Button Use this button to clear the CMOS values (e.g. BIOS configuration) and reset the CMOS values to factory defaults when needed. •• Always turn off your computer and unplug the power cord from the power outlet before using the clear CMOS button. •• Do not use the clear CMOS button when the system is on, or the system may shutdown and data loss or damage may occur. •• After system restart, go to BIOS Setup to load factory defaults (select Load Optimized Defaults). SMA Antenna Connectors (2T2R) Use this connector to connect an antenna. Tighten the antenna cables to the antenna connectors and then move the antenna to a place where the signal is good. (Note) To enable the Q-Flash Plus function, refer to "Chapter 3" of the manual. - 7 -

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
Back View-A
Q-Flash Plus Button
(Note)
This button allows you to update the BIOS when the power connector is connected but the system is not
powered on.
Clear CMOS Button
Use this button to clear the CMOS values (e.g. BIOS configuration) and reset the CMOS values to factory
defaults when needed.
•
Always turn off your computer and unplug the power cord from the power outlet before using
the clear CMOS button.
•
Do not use the clear CMOS button when the system is on, or the system may shutdown and
data loss or damage may occur.
•
After system restart, go to BIOS Setup to load factory defaults (select Load Optimized Defaults).
SMA Antenna Connectors (2T2R)
Use this connector to connect an antenna.
Tighten the antenna cables to the antenna connectors and then move the antenna to a place
where the signal is good.
(Note)
To enable the Q-Flash Plus function, refer to "Chapter 3" of the manual.
- 7 -