Gigabyte B450M DS3H V2 User Manual - Page 15

_ _ F B S_ B B 3 _ _B S B_ B _0 F 7) M2A_SOCKET (M.2 Socket 3 Connector) S The M.2 connectors support M.2 SATA SSDs or M.2 PCIe SSDs and support RAID configuration. PleSase note that an M.2 PCIe SSD cannot be used to create a RAID set either with a SATA hard drive. To create a RAID array with an M.2 PCIe SSD, you must set up the configuration in UEFI BIOS mode. Refer to Chapter 3, "C_oSnfiguring a RAID Set," for instructions on configuring a RAID array. S_ _ B 110 80 60 42 _U Follo_wB the steps below to correctly install an M.2 SSD in the M.2 cFonnector. Step 1: Use a screw driver to unfasten the screw and nut from the motherboard. Locate the proper mounting hole Ff_oUrStBh3eFM.2 SSD to be installed and then screw the nut first. Slide the M.2 SSD into the conne_c3tor at aUn angle. Step 2: Press the M.2 SSD down and then secure it with the screw. _ 0 Select the proper hole for the M.2 SSD to be installed and refasten the screw and nut. _ _F 8) SPDIF_O (S/PDIF Out Header) This header supports digital S/PDIF Out and connects a S/PDIF digital audio cable (provided by expansion cards) for digital audio output from your motherboard to certa_in0expaFnsion cards like graphics cards and sound cards. For example, some graphics cards may require you to use a S/PDIF digital audio cable for digital audio output from your motherboard to your graphics card if you wish to connect an HDMI display to the graphics card and have digital audio output from the HDMI display at the same time. For information about connecting the S/PDIF digital audio cable, carefully read the manual for your expansion card. Pin No. Definition S F_ 1 5VDUAL 2 No Pin 1 3 SPDIFO 4 GND _3 U _USB3 F_USB30 3 - 15 -