Gigabyte GA-990FXA-UD5 Manual - Page 37
CPU Host Clock Control, CPU Frequency MHz, Set Memory Clock, DCTs Mode, DDR3 Timing Items, MB
View all Gigabyte GA-990FXA-UD5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
DRAM Configuration CMOS Setup Utility-Copyright (C) 1984-2011 Award Software DRAM Configuration CPU Host Clock Control x CPU Frequency(MHz) Set Memory Clock x Memory Clock DCTs Mode DDR3 Timing Items x 1T/2T Command Timing x CAS# latency x RAS to CAS R/W Delay x Row Precharge Time x Minimum RAS Active Time x TwTr Command Delay x Trfc0 for DIMM1, DIMM3 x Trfc1 for DIMM2, DIMM4 x Write Recovery Time x Precharge Time x Row Cycle Time x RAS to RAS Delay **DCTs Drive Strength** [Auto] 200 [Auto] x6.66 1333Mhz [Unganged] [Auto] SPD Auto Auto -- -- Auto 9T 9T Auto 9T 9T Auto 9T 9T Auto 24T 24T Auto 5T 5T Auto 110ns 110ns Auto -- -- Auto 10T 10T Auto 5T 5T Auto 33T 33T Auto 4T 4T DCT0 DCT1 Item Help Menu Level Move Enter: Select F5: Previous Values +/-/PU/PD: Value F10: Save F6: Fail-Safe Defaults ESC: Exit F1: General Help F7: Optimized Defaults CMOS Setup Utility-Copyright (C) 1984-2011 Award Software DRAM Configuration ProcOdt(ohms) DQS Drive Strength Data Drive Strength MEMCLK Drive Strength Addr/Cmd Drive Strength CS/ODT Drive Strength CKE Drive Strength **DCTs Addr/Cmd Timing** Addr/Cmd Setup Time Addr/Cmd Fine Delay CS/ODT Setup Time CS/ODT Fine Delay CKE Setup Time CKE Fine Delay [Auto] 60 [Auto] 240 [Auto] 1.0x [Auto] 1.5x [Auto] 1.0x [Auto] 1.5x [Auto] 1.5x [Auto] 1.5x [Auto] 1.5x [Auto] 2.0x [Auto] 1.5x [Auto] 2.0x [Auto] 1.5x [Auto] 2.0x DCT0 DCT1 [Auto] 1/2T [Auto] 1/2T [Auto] 0/64 [Auto] 0/64 [Auto] 1/2T [Auto] 1/2T [Auto] 0/64 [Auto] 0/64 [Auto] 1/2T [Auto] 1/2T [Auto] 0/64 [Auto] 0/64 Item Help Menu Level Channel Interleaving Bank Interleaving DQS Training Control CKE Power Down Mode Memclock tri-stating [Enabled] [Enabled] [Skip DQS] [Disabled] [Disabled] Move Enter: Select F5: Previous Values +/-/PU/PD: Value F10: Save F6: Fail-Safe Defaults ESC: Exit F1: General Help F7: Optimized Defaults CPU Host Clock Control, CPU Frequency (MHz), Set Memory Clock, Memory Clock The settings under the four items above are synchronous to those under the same items on the MB Intelligent Tweaker(M.I.T.) main menu. DCTs Mode Allows you to set memory control mode. Ganged Sets memory control mode to single dual-channel. Unganged Sets memory control mode to two single-channel. (Default) DDR3 Timing Items Manual allows all DDR3 Timing items below to be configurable. Options are: Auto (default), Manual. - 37 - BIOS Setup