Gigabyte GA-B75M-D2V Manual - Page 17
F_PANEL Front Panel Header, SPEAK, MSG/PWR
View all Gigabyte GA-B75M-D2V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
8) F_PANEL (Front Panel Header) Connect the power switch, reset switch, speaker, chassis intrusion switch/sensor and system status indicator on the chassis to this header according to the pin assignments below. Note the positive and negative pins before connecting the cables. Message/Power/ Power Sleep LED Switch Speaker MSG+ MSG- PW+ PWSPEAK+ SPEAK- F_AUDIO(H) F_PANEL(NH) 2 1 20 F_PANEL 19 (H61M-D2) HD+ HD- RESRES+ CICI+ PWR+ PWR- Hard Drive Reset Activity LED Switch Power LED Chassis Intrusion Header •• MSG/PWR (Message/Power/Sleep LED): DB_PORT System Status LED Connects to the power status indicator on the chassis front panel. The LED is S0 On BIOSoSnwwitchheern(Xt5h8eA-sOyCs)tem is operating. The LED is off when the system is in S3/S4 S3/S4/S5 Off s1leep state or powered off (S5). DIP 1 23 1 DIP 1 23 1 DIP 1 23 1 •• PW (Power Switch): M_SATA Connects to the power switch on the chassis front panel. You may configure the way to turn off your system using the power switch (refer to Chapter 2, "BIOS Setup," "Power Management," for more inforAmCaPtIi_oCnP)T. Voltage measur•e•meSntPmEoAduKle((XS5p8Ae-aOkCe)r): (GA-IVB) Connects to the speakerPoWnMthSewitcchha(Xs5s8isA-fOroC)nt panel. The system reports system startup status by issuing a beep code. One single short beep will be heard if no problem is detected at system startup. •• HD (Hard Drive Activity LED): Connects to the hard drive reading or writing data. actDiIvP ity 1 23 LED on the chassis front panel. The LED is on when the harSdMdBr_ivCePTis (GA-IVB) PCIe power••conRnEecStor(R(SeATsAe)t(XS5w8Ait-cOhC)): Connects to the reset switch on the chassis front panel. Press the reset switch to restart the computer if the computer freezes and fails to perform a normal restart. •• CI (Chassis Intrusion Header): Connects to the chassis intrusion switch/sensor on the chassis that can detect if the chassis coCvLRe_rChMaOsS been removed. This function requires a chassis with a chassis intrusion switch/sensor. CI DIS_ME GP15_CPT (GA-IVB) ement points(G1.Sniper 3) BIOS Switcher (SW4) XDP_CPU XDP_PCH (GA-IVB) The front panel design may differ by chassis. A front panel module mainly consists of power switch, reset switch, power LED, hard drive activity LED, speaker and etc. When connecting your chassis front panel module to this header, make sure the wire assignments and the pin assignments are matched correctly. - 17 -