Gigabyte GA-F2A58M-H User Manual - Page 15

1 23 1 1 23 1 SS 1 S 1 23 U 1 23 1 8) F_PANEL (Front Panel Header) Connect the power switch, reset switch, speaker, and system status indicator on the chassis to this header according to the pin assignments below. Note the positive and negative pins before connecting the cables. Power LED Power Switch Speaker •• PLED/PWR_LED (Power LED): PLED+ PLED- PW+ PWSPEAK+ SPEAK- System Status LED S0 On S3/S4/S5 Off Connects to the power status indicator on the chassis front panel. The LED is on when the system is operating. The LED is off when the system is in S3/S4 sleep state F_ 2 1 20 19 •• CPWoFn_n(PeocwtsetroStwheitcpho):wer or powered off (S5). S S U switch on the chassis front panel. 12345 You may HD+ HD- RESRES+ CICI+ PWR_LED+ PWR_LEDPWR_LED- configure the way to turn off your system using the power switch (refer to Chapter 2, "BIOS Setup," "Power Management," for more information). •• SPEAK (Speaker): Hard Drive Reset Power LED Activity LED Switch Chassis Intrusion Header Connects to the speaker on the chassis front panel. The system reports system startup status by issuing a beep code. One single short beep will be heard if no problem is detected at system startup. •• HD (Hard Drive Activity LED): Connects to the hard drive activity LED on the chassis front panel. The •• RES (Reset Switch): LED is on when the hard drive is reading or writing data. Connects to the reset switch on the chassis front panel. Press the reset switch to restart the computer if the computer freezes and fails to perform a normal restart. _S •• CI (Chassis Intrusion Header): Connects to the chassis intrusion switch/sensor on the chassis that can detect if the chassis cover has been removed. This function requires a chassis with a chassis intrusion switch/sensor. _ B S_ The front panel design may differ by chaBssis. A front panel module mainly consists of poweBr switch, reset switch, power LED, hard drive activity LED, speaker and etc. When connecting your chassis front panel module to this header, make sure the wire assignments and the pin assignments are matched correctly. 9) F_AUDIO (Front Panel Audio Header) The front panel audio header supports ISnBte_l High Definition audio (HD) and AC'97 audio. You may connect your chassis front panel audio module toB this header. Make sure the wire assignments of the module connector match the pin assignments of the motherboard header. Incorrect connection between the module connector and the motherboard header will make the device unable to work or even damage it. 9 1 10 2 __ 3 For HD Front Panel Audio: Pin No. Definition 1 MIC2__L S 2 GND S_ 3 MIC2__RB 4 -ACZ_DET 5 LINE2_R 6 GND _ U 7 FAUDI_OB_JD 8 No Pin 9 LINE2_L 10 GF_NUDSB3 F For AC'97 Front Panel Audio: Pin No. Definition 1 MIC 2 GND 3 MIC Power 4 NC 5 Line Out (R) 6 NC 7 NC 8 No Pin 9 Line Out (L) 10 NC •• The front panel audio header supports HD audio by default. •• Audio signals will be present on both of the front and back panel audio connections simultaneously. •• Some chassis provide a front panel audio module that has separated connectors on each wire instead of a single plug. For information about connecting the front panel audio module that has different wire assignments, please contact the chassis manufacturer. - 15 -