Gigabyte GA-H61M-S2PH Manual - Page 13

PORT DEBUG PORT DEBUG PORT 5) SATA2 0/1/2/3 (SATA 3Gb/s Connectors) The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. SATA2 1 7 0 1 71 1 72 3 1 7 Pin No. 1 2 3 4 5 6 7 Definition GND TXP TXN GND RXN RXP GND 6) F_PANEL (Front Panel Header) Connect the power switch, reset switch, speaker, and system status indicator on the chassis to this header according to the pin assignments below. Note the positive and negative pins before connecting the cables. Power/Sleep LED Power Switch Speaker •• PLED/PWR (Power/Sleep LED): System Status LED Connects to the power status indicator PLED+ PLED- PW+ PWSPEAK+ SPEAK- S0 On on the chassis front panel. The LED is on S3/S4/S5 Off when the system is operating. The LED is off when the system is in S3/S4 sleep state F_PANEL(NH) 2 1 20 19 •• PW (F(PH_o6P1wAMNe-EDrL2S) witch): or powered off (S5). PWM Switch (SW1)(X79-UD7) DIP 12345 Connects to the power switch on the chassis front panel. You may HD+ HD- RESRES+ CICI+ PWR+ PWR- configure the way to turn off your system using the power switch (refer to Chapter 2, "BIOS Setup," "Power Management," for more Hard Drive Reset Activity LED Switch Power LED Chassis Intrusion Header information). •• Speaker (Speaker): Connects to the speaker on the chassis front panel. The system reports system startup status by issuing a beep code. One single short beep will be heard if no problem is detected at system startup. BIOS Switcher (X58A-OC) •• HD (Hard Drive Activity LED): Connects to the hard drive activity LED on the chassis front panel. The DIP 1 23 1 1 LED is on when the hard drive is reading or writing data. DIP 1 23 1 M_SATA •• RES (Reset Switch): DIP 1 23 1 Connects to the reset switch on the chassis front panel. Press the PWM Switch (X58A-OC) reset switch to restart the computer if the computer freezes and fails to peA(rGfCoAPr-IIm_VCBaP) Tnormal restart. BIOS_PH (GA-IVB) •• CI (Chassis Intrusion Header): Connects to the chassis intrusion switch/sensor on the chassis that can detect if the chassis cover has been removed. This function requires DIP a chassis with a chassis intrusion switch/sensor. 1 23 SMB_CPT The front panel design may differ by ch(aGsAs-iIsV.BA) front panel module mainly consists of power switch, reset switch, power LED, hard drive activity LED, speaker and etc. When connecting your chassis front panel module to this header, make sure the wire assignments and the pin assignments are matched correctly. - 13 - CLR_CMOS CI DIS_ME GP15_CPT (GA-IVB)