Gigabyte GA-VM900M Manual - Page 65

English Step 3: If Setup correctly recognizes the driver in the floppy disk, a controller menu similar to Figure 18 below will appear. If you want to install Windows XP, use the ARROW keys to select VIA V-RAID Controller Series (Windows XP/SRV2003) (Note) and press ENTER. Then it will begin to load the SATA driver from the floppy disk. Windows Setup You have chosen to configure a SCSI Adapter for use with Windows, using a device support disk provided by an adapter manufacturer. Select the SCSI Adapter you want from the following list, or press ESC to return to the previous screen. VIA V-RAID Controller Series (Windows XP/SRV2003) VIA V-RAID Controller Series (Windows XP/SRV2003-x64) VIA V-RAID Controller Series (Windows 2K) VIA V-RAID Controller Series (Windows NT4) ENTER=Select F3=Exit Figure 18 If a message appears saying one or some file(s) cannot be found, please check the floppy disk or copy the correct SATA driver again from the motherboard driver CD. Step 4: When the screen as shown below appears, press ENTER to continue the SATA driver installation from the floppy disk. The driver installation will be finished in about one minute. Windows Setup Setup will load support for the following mass storage device(s): VIA V-RAID Controller Series (Windows XP/SRV2003) * To specify additional SCSI adapters, CD-ROM drives, or special disk controllers for use with Windows, including those for which you have a device support disk from a mass storage device manufacturer, press S. * If you do not have any device support disks from a mass storage device manufacturer, or do not want to specify additional mass storage devices for use with Windows, press ENTER. S=Specify Additional Device ENTER=Continue F3=Exit Figure 19 (Note) For 64-bit Windows Operating System, please select VIA V-RAID Controller Series (Windows XP/SRV2003-x64). - 65 - Appendix