Gigabyte GS-R12P4E Manual - Page 21

Installing the Hard Disk Drive

Get Gigabyte GS-R12P4E PDF manuals and user guides View all Gigabyte GS-R12P4E manuals
Add to My Manuals
Save this manual to your list of manuals

Page 21 highlights

2-6 Installing the Hard Disk Drive Read the following guidelines before you begin to install the Hard disk drive: • Take note of the drive tray orientation before sliding it out. • The tray will not fit back into the bay if inserted incorrectly. • Make sure that the HDD is connected to the HDD connector on the backplane. 2-6-1 GS-R12P4E/GS-R12P4F Hard Disk Drive Installation Follow these instructions to install the Hard disk drive: 1. Press the release button. 2. Pull the locking lever to remove the HDD tray. 3. Slide hard disk into blank. 4. Secure the hard drive to the tray with four (4) screws as shown. Do not over tighten thescrews. 5. Slide the blank into the bay until it locks into place. 3 4 4 1 2 - 21 - Hardware Installation

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
- 21 -
Hardware Installation
2-6
Installing the Hard Disk Drive
Read the following guidelines before you begin to install the Hard disk drive:
•
Take note of the drive tray orientation before sliding it out.
•
The tray will not fit back into the bay if inserted incorrectly.
•
Make sure that the HDD is connected to the HDD connector on the backplane.
2-6-1
GS-R12P4E/GS-R12P4F Hard Disk Drive Installation
Follow these instructions to install the Hard disk drive:
1.
Press the release button.
2.
Pull the locking lever to remove the HDD tray.
3.
Slide hard disk into blank.
4.
Secure the hard drive to the tray with four (4) screws as shown. Do not over tighten thescrews.
5.
Slide the blank into the bay until it locks into place.
2
1
3
4
4