Gigabyte MATMH81 Manual - Page 28

F_PANEL Front Panel Header

Get Gigabyte MATMH81 PDF manuals and user guides View all Gigabyte MATMH81 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 28 highlights

26) F_PANEL (Front Panel Header) Connect the power switch, reset switch, speaker, chassis intrusion switch/sensor and system status indicator on the chassis to this header according to the pin assignments below. Note the positive and negative pins before connecting the cables. 2 10 1 9 Pin No. 1 2 3 4 5 6 7 8 9 10 Signal Name HD+ MPD+ HD- GND GND -PWRBT_F -SYS_RST GND NC NC Definition Hard Disk LED Signal anode (+) Power LED Signal anode (+) Hard Disk LED Signal cathode(-) Ground Ground Power Button cathode(-) Reset Button Ground No connect No Pin The front panel design may differ by chassis. A front panel module mainly consists of power switch, reset switch, power LED, hard drive activity LED, speaker and etc. When connecting your chassis front panel module to this header, make sure the wire assignments and the pin assignments are matched correctly. - 28 - Hardware Installation

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
- 28 -
Hardware Installation
26) F_PANEL (Front Panel Header)
Connect the power switch, reset switch, speaker, chassis intrusion switch/sensor and system status
indicator on the chassis to this header according to the pin assignments below. Note the positive and
negative pins before connecting the cables.
2
1
10
9
The front panel design may differ by chassis. A front panel module mainly consists of power switch,
reset switch, power LED, hard drive activity LED, speaker and etc. When connecting your chassis
front panel module to this header, make sure the wire assignments and the pin assignments are
matched correctly.
Pin No.
Signal Name
Deļ¬nition
1
HD+
Hard Disk LED Signal anode (+)
2
MPD+
Power LED Signal anode (+)
3
HD-
Hard Disk LED Signal cathode(-)
4
GND
Ground
5
GND
Ground
6
-PWRBT_F
Power Button cathode(-)
7
-SYS_RST
Reset Button
8
GND
Ground
9
NC
No connect
10
NC
No Pin