Gigabyte Sumo 4112 User Manual - Page 10

(2) Basic casing power switch control cable kit Follow the connectors list below for installation (see figure below) Connector Power LED Power SW Color Green(+) / Wite(-) Orange(+) / White(-) 4-5 Connection of Fan Power Cable This chassis has 1 x 12cm silent cooling fan at the front and 1 x 12cm silent fan at the rear. There are internal connectors that connect the front and rear fans making it into a single 3-pin power connector. Required Tools: None 4-5.1 Insert the 3-pin connector into the system fan power connector on the motherboard. Different Motherboards have different installation areas, specifications, screw holes and connectors. Please read the motherboard user manual supplied by the motherboard manufacturer. 4-6 Installation of 5.25" Front Device Bay 4-6-1 Open the front panel door and side panel, remove the plastic bezel and aluminum EMI plate through the inside of the chassis. 4-6-2 Slide-in the 5.25" device through the front panel to align it with the front panel bezels. 4-6-3 Secure the 5.25" device with the internal latch. Refer to the figure for installation procedure. 4-6-4 Installation complete. 4-6.1 4-6.2 4-6.3 LOCK 4-6.4 4-7 Installation of 3.5" Front Device Bay The Installation of the 3.5" front device is the same as the installation of the 5.25" front devices. Please refer to step 4-6. Required parts: none 4-8 Installation of 3.5" Internal Device Bay This chassis provides built-in bays to accommodate up to 5 hard disc drives (after removal of the tool enclosure). The HDD requires securing runners, which can be found in the tool enclosure. 4-8-1 Place the runners on both sides of the HDD. Slide the HDD into the hard disk bay evenly. 4-8-2 For installations of the fourth and fifth HDDs, loosen the tool enclosure, and then install the HDD in accordance with step 4-8-1. 4-8.1 4-8.2 10 English