Haier 3U19FS1ERA Service Manual - Page 133
ÜÑ×ØÄÜ, ÄÝÒÑâ, ÏÜÑÏð, âÑÕÑÄ, ÕÑÄ, ÄÝÒÑ
View all Haier 3U19FS1ERA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 133 highlights
ON/OFF operation MODE COOL FAN HIGH OPERATION CLOCK C ROOM TEMP. MODE FAN SWING HEALTH TEMP CLOCK TIME TIMER SET RECOVERY CHECK FILTER RESET ON/OFF >_]]VbTZR\ _^UZdZ_^Vb 2 Press ON/OFF switch on line controller directly The line controller displays the running state in the latest 4 time (timing and swing state may not be displayed). 1. Press "ON/OFF" switch. 5 The air conditioner starts operating, and the light on the wired controller is on. 3 2.Choose operation mode. Press "mode"switch to change to "AUTO"---"FAN ONLY"---"COOL"---"DRY"---"HEAT". 3.Press "TEMP" switch Change set temperature:press TEMP or TEMP every time, [SET] will display,and set temperature will increase/reduce 1 4.Press "FAN SPEED" switch 6 FAN ONLY Operation: Press "FAN SPEED" switch to change to "HIGH"--"MED"--"LOW"--"HIGH" In AUTO,COOL,DRY,HEAT Operation: Press "FAN SPEED" switch to change to "AUTO"--"HIGH"--"MED"--"LOW"--"AUTO" 5.Press "swing" switch on the line controller to swing the wind screen. 6.Press "ON/OFF"switch, off. The light on the line controller is off. Note Several seconds after the operation of the line controller, the setting of the unit will change. Remarks Avoid pressing "ON/OFF" switch frequently. Do not press line controller or switches by sharp objects. The temperature is on the basis of the setting value. The wind temperature may not reach the setting value because of the outer air conditioner and system protection. When the wired controller is power on, the screen fully displays it for two seconds. and clock zone "8888"-"888"-"88""8" flicker for 30 seconds. All the switches are invalid at the time.