Haier DW12-TFE2WH User Manual - Page 6
Installation
View all Haier DW12-TFE2WH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Installation Positioning the appliance Positioning the appliance in the desired location. The back should rest against the wall behind it, and the sides, along the adjacent cabinets or wall. The dishwasher is equipped with water supply and drain hoses that can be positioned to the right or the left to facilitate proper installation. Levelling the appliance Once the appliance is positioned, adjust the feet (screwing them in or out) to adjust the dishwasher, making it level. In any case, the appliance should not be inclined more than 2˚. If the appliance is level, it will help ensure proper performance. Cold water connection Connect the water supply hose to a threaded 3/4" bsp connector, making sure that it is fastened tightly in place (see fig.A). If the water pipes are new or have not been used for an ex- tended period of time, let the water run to make sure that the water is clear and free of impurities. If this precaution is not taken, there is a risk that the water inlet can get blocked and damage fig.A the appliance. The appliance is to be connected to the water mains using new hose-sets and that old hose-sets should not be reused. Water pressure 300 - 1000KPa. A Pressure limiting valve is required where water pressure exceeds 1000KPa. Drain hose connection Insert the drain hose into a drain pipe with a minimum diameter of 4cm, or let it run into the sink, making sure to avoid bending or crimping it. If necessary, fit a syphon trap (U-bend) with a connecting piece for the drain hose (fig.B). The free end of the hose must be at a height between 40 and 100cm and must not be immersed in water. fig.B1 4