Haier DW15-PFE2 User Manual - Page 16

Switching the dishwasher ON • Turn on the tap. • Set ON-OFF button " A " to ON. All the programme indicators "K1,K2,K3,K4,K5,K6 " light . Press programme button "J1" , programme indicator Kl" blinks and the time-remaining indicator " F " displays the time of the programme.. If the door is closed, after 5 seconds, the programme indicator " Kl" bcomes to light and the dishwasher beeps one time , then the programme starts automatically. A K1 K2 K3 K4 K5 K6 J1 O •O 0 (__) 1 12 F End of programme • Six beeps will indicate that the wash cycle has finished and all the programme indicators light. Switching the dishwasher OFF Several minutes after the programme has ended: • Set main switch "A" to OFF. • Open the door . • Turn the water tap off. (Does not apply when Aquastop unit has been fitted) • Remove dishes, etc. when they have cooled down. Interrupping the programme Open the door. Caution! There is a risk of water squirting out from inside the appliance. Do not open the door fully until spray arm has stopped rotating. • When you open the door, the dishwasher will beep ten times every thirty seconds. • If the appliance has already heated up or the hot water was switched ON and then the appliance door opened, leave the door ajar for several minutes and then close. Otherwise, the appliance door may open due to expansion. 18 lip')1nin npoin I t 11w rIp o '17'3 lymn J' .0'11D -ryi.nn v.) -inina Ill 1x iwnnwn ,nn-rnn lrrnn ID '3917 .ipun nnin 'Dm nx On'? .ipqn nnin `73.n.pri'm niuDinn 311711311 oxnna .n.-rnn n'n .n.39n nem npinn .ip.3 -min npoin ."6" iYn11 `7v unL7 ,"5" nopn nn.n9L7 • ."7" xth croin`7 nn-rn`? .Ip.3 lnrn • ."8" xth crow* nn-rn-o-rp`i v.) -min • unin noDnn nx nao ,.ip.3 lnrn npoin -inx`7 • .IT111'11311111 Pin/ ;um nx n.on ,nopnn I7V/ n irm. rn.ao`7 .o.xnn nup `73) 19V13W .ip.3n 16