Haier HD100-A2939S User Manual - Page 25

EN 12-Installation Notice: all installation relevant pictures can be found at the beginning of this manual. 12.1 Preparation ▶ Remove all packages including the polystyrene base firstly. While removing the package, water drops may be observed. This is normal phenomenon results from water test the factory. Notice Dispose of the package in an environmental friendly manner. For information referring to current disposal sites, consult your retailer or the local authorities. WARNING! After transportation and installation, you MUST leave the dryer to stand for two hours before use. 12.2 Transport and waiting time Transport the appliance in horizontal position only. To the maintenance-free lubrication oil is located in the capsule of the compressor. This oil can get through the closed pipe system during slanting transport. Before connecting the appliance to the power supply you have to wait 2 hours so that the oil runs back into the capsule. 12.3 Place the appliance The appliance should be placed on a flat and solid surface. Set the feet to the desired level(Fig.12-1). 12.4 Installation under worktop The dimensions of the recess should at least match with the dimensions( F ig.12-2). 1. Put the appliance adjacent to the slot. Make sure that all connections are easily accessible and functional. 2. Adjust accurately all feet to get a firm level position. 3. Install the appliance prudently into the recess. 4. Make sure a sufficient ventilation. 12.5 Electrical connection Before each connection check if: ▶ power supply, socket and fusing are appropriate to the rating plate. ▶ the power socket is earthed and no multi-plug or extension. ▶ the power plug and socket are strictly match. ▶ Only UK: The UK plug meets BS1363A standard Put the plug into the socket(Fig.12-3). WARNING! If the supply cord is damaged, it must be replaced by the service agent (see warranty card) in order to avoid a hazard! 25