Haier HDV70E1 User Manual - Page 11
Internal venting, External venting
View all Haier HDV70E1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
INSTALLATION INSTRUCTIONS Before a rear venting option is installed the dryer must be changed from the front venting factory setup. Remove the outlet grille from the front left-hand side and replace with the outlet cover from the rear left-hand side. These covers should be gently pried at the sides to prevent damage. Internal venting Front venting is the only option for internal venting. The dryer is set up for front venting when it leaves the factory. Note: where possible all efforts should be made to vent the dryer externally to avoid moisture build up around the dryer. External venting The dryer can be vented directly through the wall with a flexible hose, in combination with the hose connector supplied with the dryer. Tools and parts required: ■ Slotted screwdriver kit part includes: ■ 1 x Hose connector ■ 1 x Flexible hose ■ 1 x Flexible hose clip Flexible hose clip Flexible hose Hose connector Connect the narrow end of the connector to the dryer duct pipe mouth at the back of the dryer. Then connect the flexible hose to the wide end of the connector. Use the clip to fasten connection point between the flexible hose and connector (fasten clip with a screwdriver). Extend the flexible hose through the duct hole, make sure the flexible hose is not twised to allow the air to be vented outside. Note: The vent system should be a maximum of two metres with no more than three 90° bends. 10