Haier HH-OT53P HH-OT53P Manual - Page 10

work, motor does not work Mains power cable is loose or disconnected Refit mains power cable to power outlet. Switch power outlet on. Oil leakage One way valve and the outlet are not tightly sealed Take down the one way valve and seal with sealant. Leakage from the connection of chimney and cover Take chimney down and seal. Lights not working Broken or faulty bulbs Replace blubs as per this instruction. Insufficient suction The distance between the cooker hood and the gas top is too far Refit the cooker hood to the correct distance. The Cooker hood The fixing screw is not tight inclines enough Tighten the hanging screw and make it horizontal. NOTE: Any electrical repairs to this appliance must conform to your local, state and federal laws. Please contact the service centre if in any doubt before undertaking any of the above. Always disconnect the unit from the power source when opening the unit. MAINTENANCE AND CLEANING Caution: • Before maintenance or cleaning is carried out, the cooker hood should be disconnected from the mains power supply. Ensure that the cooker hood is switched off at the wall socket and the plug removed. • External surfaces are susceptible to scratches and abrasions, so follow the cleaning instructions to ensure the best possible result is achieved without damage. GENERAL Cleaning and maintenance should be carried out with the appliance cold especially when cleaning. Avoid leaving alkaline or acid substances (lemon juice, vinegar etc.) on the surfaces. STAINLESS STEEL The stainless steel must be cleaned regularly (e.g.weekly) to ensure a long life expectancy.Dry with a clean soft cloth. A specialized stainless steel cleaning fluid may be used. NOTE: Ensure that wiping is done along with the grain of the stainless steel to prevent any unsightly crisscross scratching patterns from appearing. CONTROL PANEL SURFACE 10