Haier HH-OT53P HH-OT53P Manual - Page 12

NOTE:  Make sure the filter is securely locked. Otherwise, it would loosen and cause danger.  When activated carbon filter attached, the suction power will be lowered. BULB REPLACEMENT Important :  The bulb must be replaced by the manufacturer, its service agent or similarly qualified persons.  Always switch off the electricity supply before carrying out any operations on the appliance. When handling bulb, make sure it has completely cooled down before any direct contact with hands.  When handling bulbs hold with a cloth or gloves to ensure perspiration does not come in contact with the bulb as this can reduce the life of the bulb. Note:  Before changing the lights, make sure that the appliance is turned off and unplugged.  Protect against danger when changing lights, such as wearing gloves. Changing the lights:  Remove the grease filter.  Loosen two screws of the lamp plate and take down the lamp plate.  Use a screwdriver to prize up the terminal box of the light connection wire, and then pull out the terminal plastic base of the light connection wire. See pic 1.  Use a tool or your hand to press the spring splinter of both sides of LED light to the inside, until the light is pressed out, then slightly pull the light connection wire out. See pic 2& 3.  Apply the reverse procedure to reinstall the light. • ILCOS D code for this lamp is: DBR-2/65-H-64 - LED modules -round lamp - Max wattage: 2×2 W - Voltage range: AC 110-240V - Dimensions: 12