Haier HH-OT53P HH-OT53P Manual - Page 11

The inlay control panel can be cleaned using warm soapy water. Ensure the cloth is clean and well wrung before cleaning. Use a dry soft cloth to remove any excess moisture left after cleaning. Important Using neutral detergents and avoid using harsh cleaning chemicals, strong household detergents or products containing abrasives,as this will affect the appearance of the appliance and potentially remove any printing of artwork on the control panel and will void manufactures warrantee. GREASE MESH FILTERS The mesh filters can be cleaned by hand. Soak them for about 3 minute in water with a mild detergent and then brush it gently with a soft brush. Do not apply too much pressure so as to avoid any damage to it . (Leave to dry naturally out of direct sun light.) Filters should be washed separately to crockery and kitchen utensils. It is advisable not to use rinse aid. INSTALLING GREASE MESH FILTERS • To install filters for the following four steps: - Angle the filter into the slots at the back of the hood. - Push the button on the handle of the filter. - Release the handle once the filter fits into a resting position. - Repeat to install all filters. CARBON FILTER Activated carbon filter can be used to trap odors. Normally the activated carbon filter should be changed every 3 to 6 months according to your cooking habits. The installation procedure of the activated carbon filter is as below: 1. Before installing or replacing the carbon filters, disconnect the mains power to the unit. 2. Press the filter lock and remove the mesh filter. 3. Turn the carbon filter on both sides of the motor anti-clockwise. Replace the carbon filters with the new carbon filters. 4. Place the mesh filter. 5. Connect the power supply to the wall socket. 11