Haier HLP021 User Manual - Page 17

English Steps for the Wash Process 1. The lint filter must be cleaned and in place before you start washing. 2. Turn the power ON by pressing the "ON" button. 3. Press "Cycle Select" to select the wash program. 4. Select the water level. 5. Add the detergent. 6. Add the wash load. 7. Press the Start / Pause button. 8. After the washing machine starts, you may change the Cylcle or program by turning OFF the machine and then restarting to make the new selection. Note: If the washer is turned ON without any water in the tub, it will start to spin after a few minutes. The pulsator will not rotate unless the water is filled to a selected level. Note: Do not use the "HEAVY Wash" program for woolen clothing. Note: Loading the Washer • Load each item loosely. • Separate the white from the colored clothing. Separate heavy fabrics from light fabrics. • Carefully check all pockets and cuffs for foreign items. They can easily slide into the tub and cause damage to the tub and/or make disturbing noises during cycles. • Always balance the laundry load evenly within the washer tub, so there is no single heavy areas and all the laundry is evenly distributed. Lint Filter and Water Filter • The Lint filter is located inside the washer drum. A small nylon bag collects lint and residue from clothes during the wash cycle. Note: NEVER wash your clothes without the filter in its compartment inside the tub. • You must clean the filter after every load for the best results. Push down the tab in the filter to remove. Clean and slide the filter back in place. • There is also a filter in the water inlet valve. This prevents foreign particles in the water from entering the washer. Clean this at least once a month. L„.„.2.4 16