Haier HMV1630DBBB HMV1630 Installation Guide - Page 23
C. Recirculating
View all Haier HMV1630DBBB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
English C. RECIRCULATING (NON-VENTED DUCTLESS) INSTALLATION OVERVIEW C1. Attach Mounting Plate to Wall C2. Prepare Top Cabinet C3. Check Blower Plate C4. Mount the Microwave Oven C5. Install or change Charcoal Filter IMPORTANT NOTES: t Make sure the screws for the blower motor and blower plate are securely tightened when they are reinstalled. This will help to prevent excessive vibration t Make sure the motor wiring has been properly routed and secured, and that the wires are not pinched. C1. ATTACH THE MOUNTING PLATE TO THE WALL Attach the plate to the wall using toggle bolts. At least one wood screw must be used to attach the plate to a wall stud. 1. Remove the toggle wings from the bolts. 2. Insert the bolts into the mounting plate through the holes designated to go into drywall and reattach the toggle wings to 3⁄4" (19 mm) onto each bolt. TO USE TOGGLE BOLTS: 3. Place the mounting plate against the wall and insert the toggle wings into the holes in the wall to mount the plate. Mounting NOTE: Before tightening toggle bolts and wood screw, Plate make sure the tabs on the mounting plate touch the bottom of the cabinet when pushed flush against the wall and that the plate is properly centered under the cabinet. CAUTION: Be careful to avoid pinching fingers between the back of the mounting plate and thewall. Spacing for Toggles More Than Wall Thickness Toggle Wings Toggle Bolt Wall Bolt End 4. Tighten all bolts. Pull the plate away from the wall to help tighten the bolts. 22